How to Correct Wrinkled VHS Tapes

Ironing out the wrinkle in a VHS tape takes patience and a lot of care. Unlike a wrinkled audio cassette tape, which is thinner and can be manually rewound with a pencil or a finger, a wrinkled VHS tape is more difficult to straighten. If a tape hasn't been played for some time, then problems can occur with wrinkles. If the wrinkle is not corrected, then the tape will become unplayable and will get jammed in the video tape recorder. Eventually the tape may snap in two.

...
A wrinkle in a VHS tape takes patience to iron out,

Step

Press the "Eject" button on your video tape recorder. Carefully remove your VHS tape.

Step

Flip the VHS tape over on a flat surface. Use a screwdriver to remove the back part of the tape. Be careful that the parts of the VHS tape, including rollers and springs, do not fall out.

Step

Turn the VHS tape back over again, after you have removed all the screws. You will now be able to determine where the wrinkle begins on the tape. Next, turn the VHS tape around.

Step

Move the tape manually by moving either tape spool. If the wrinkle is in the right tape spool, then move the left spool in an counterclockwise direction until the source of the wrinkle is discovered. If the wrinkle is on the tape in the left spool then move the right tape spool in a clockwise direction. If the wrinkle is in the middle of the tape between the rollers, then move either tape spool until you have found where the wrinkle begins from.

Step

Use your fingers to touch only the edges of the tape and manually straighten the VHS tape out. Next, manually turn the tape spool to check that this has been done correctly and that no wrinkle is visible.

Step

Connect the VHS tape together again with the screwdriver. Put it back into the video tape recorder. Play the tape for a few seconds and rewind and fast forward over the area where the wrinkle was. These final three steps will prove whether the VHS tape is functioning correctly.